kinnekoの日記: [N] USB-ET/TX
起動時に rh6.x 系のように UHCI,OHCI を並べて認識しなくなって
行儀がいいね。
USB-ET/TX を挿す。無事、認識する。
hub.c: port 1 connection change
hub.c: port 1, portstatus 101, change 1, 12 Mb/s
hub.c: port 1, portstatus 103, change 10, 12 Mb/s
hub.c: USB new device connect on bus1/1, assigned device number 2
usb.c: kmalloc IF c058d7e0, numif 1
usb.c: new device strings: Mfr=1, Product=2, SerialNumber=3
usb.c: USB device number 2 default language ID 0x409
Manufacturer: I-O DATA DEVICE, INC
Product: I-O DATA USB-ET/TX
SerialNumber: 0001
usb.c: unhandled interfaces on device
usb.c: USB device 2 (vend/prod 0x4bb/0x904) is not claimed by any active driver.
Length = 18
DescriptorType = 01
USB version = 1.10
Vendor:Product = 04bb:0904
MaxPacketSize0 = 8
NumConfigurations = 1
Device version = 1.01
Device Class:SubClass:Protocol = 00:00:00
Per-interface classes
Configuration:
bLength = 9
bDescriptorType = 02
wTotalLength = 0027
bNumInterfaces = 01
bConfigurationValue = 01
iConfiguration = 00
bmAttributes = a0
MaxPower = 160mA
Interface: 0
Alternate Setting: 0
bLength = 9
bDescriptorType = 04
bInterfaceNumber = 00
bAlternateSetting = 00
bNumEndpoints = 03
bInterface Class:SubClass:Protocol = 00:00:00
iInterface = 00
Endpoint:
bLength = 7
bDescriptorType = 05
bEndpointAddress = 81 (in)
bmAttributes = 02 (Bulk)
wMaxPacketSize = 0040
bInterval = 00
Endpoint:
bLength = 7
bDescriptorType = 05
bEndpointAddress = 02 (out)
bmAttributes = 02 (Bulk)
wMaxPacketSize = 0040
bInterval = 00
Endpoint:
bLength = 7
bDescriptorType = 05
bEndpointAddress = 83 (in)
bmAttributes = 03 (Interrupt)
wMaxPacketSize = 0008
bInterval = 01
usb.c: kusbd: /sbin/hotplug add 2
pegasus.c: pegasus.c: v0.4.18 2001/03/18 (C) 1999-2000 Petko Manolov (petkan@dce.bg)
usb.c: registered new driver pegasus
divert: allocating divert_blk for eth1
pegasus.c: intr interval will be changed from 1ms to 128ms
pegasus.c: eth1: IO DATA USB ET/TX
usb.c: pegasus driver claimed interface c058d7e0
hub.c: port 1 connection change
hub.c: port 1, portstatus 100, change 3, 12 Mb/s
usb.c: USB disconnect on device 2
divert: freeing divert_blk for eth1
usb.c: kusbd: /sbin/hotplug remove 2
hub.c: port 1 enable change, status 100